96 Address Table Commands
Example
The following example adds a permanent static MAC-layer station source address 3aa2.64b3.a245 on
port g8 to the bridge table.
bridge multicast filtering
The bridge multicast filtering Global Configuration mode command enables filtering of Multicast
addresses. To disable filtering of Multicast addresses, use the no form of the bridge multicast filtering
command.
Syntax
• bridge multicast filtering
• no bridge multicast filtering
Default Configuration
Disabled. All Multicast addresses are flooded to all ports.
Command Mode
Global Configuration mode.
User Guidelines
• If devices exist on the VLAN, do not change the unregistered Multicast addresses state to drop on the
devices ports.
• If Multicast routers exist on the VLAN and IGMP-snooping is not enabled, the
bridge multicast
forward-all
command should be used to enable forwarding all Multicast packets to the Multicast
routers.
Example
In this example, bridge Multicast filtering is enabled.
Console (config)# interface vlan 2
Console (config-vlan)# bridge address 3a:a2:64:b3:a2:45 ethernet
g8 permanent
Console (config)# bridge multicast filtering
5400_CLI.book Page 96 Wednesday, December 17, 2008 4:33 PM
To Next Page
Loading...
