70 Command Modes
LC (Line Configuration) Mode
MA (Management Access-level) Mode
PE (Privileged User EXEC) Mode
Command Description
enable authentication Specifies the authentication method list when accessing a higher privilege level
from a remote telnet or console.
exec-banner Enables the display of exec banners.
exec-timeout Configures the interval that the system waits until user input is detected.
history Enables the command history function.
history size Changes the command history buffer size for a particular line.
login-banner Enables the display of login banners.
motd-banner Enables the display of message-of-the-day banners.
password Specifies a password on a line.
autobaud
Sets the line for automatic baud rate detection
speed Sets the line baud rate.
Command Description
deny (management) Defines a deny rule.
permit (management) Defines a permit rule.
Command Description
boot system Specifies the system image that the device loads at startup.
clear arp-cache Deletes all dynamic entries from the ARP cache.
clear bridge Removes any learned entries from the forwarding database.
clear gvrp statistics Clears all the GVRP statistics information.
clear host Deletes entries from the host name-to-address cache
clear host dhcp Deletes entries from the host name-to-address mapping received from Dynamic
Host Configuration Protocol (DHCP).
clear ipv6 neighbors Deletes all entries in the IPv6 neighbor discovery cache, except static entries.
clear logging Clears messages from the internal logging buffer.
5400_CLI.book Page 70 Wednesday, December 17, 2008 4:33 PM
To Next Page
Loading...
