Address Table Commands 107
show bridge address-table static
The show bridge address-table static Privileged EXEC mode command displays statically created entries
in the bridge-forwarding database.
Syntax
•
show bridge address-table static
[
vlan
vlan
] [
ethernet
interface
|
port-channel
port-channel-number
]
Parameters
•
vlan
— Specifies a valid VLAN, such as VLAN 1.
•
interface —
A valid Ethernet port
number
.
•
port-channel-number
— A valid port-channel number.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode.
User Guidelines
• There are no user guidelines for this command.
Example
In this example, all static entries in the bridge-forwarding database are displayed.
Console# show bridge address-table static
Aging time is 300 sec
vlan mac address port type
---- ----------- ---- ----
1 00:60:70:4C:73:FF g8 permanent
1 00:60:70:8C:73:FF g8 delete-on-timeout
200 00:10:0D:48:37:FF g8 delete-on-reset
5400_CLI.book Page 107 Wednesday, December 17, 2008 4:33 PM