282 Port Channel Commands
Syntax
•
interface range
port-channel
{
port-channel-range | all
}
•
port-channel-range
— List of port-channels to configure. Separate non-consecutive port-channels
with a comma and no spaces. A hyphen designates a range of port-channels.
•
all
— All the channel-ports.
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode.
User Guidelines
• Commands under the interface range context are executed independently on each interface in the
range: If the command returns an error on one of the interfaces, it will not stop the execution of the
command on other interfaces.
Example
The following example shows how port-channels 1, 2 and 8 are grouped to receive the same command.
channel-group
The channel-group Interface Configuration mode command associates a port with a port-channel. Use
the no form of this command to remove a port from a port channel.
Syntax
•
channel-group
port-channel-number
mode
{
on
|
auto
}
• no channel-group
•
port-channel_number
— Specifies the number of the valid port-channel for the current port to
join.
•
on
— Forces the port to join a channel.
•
auto
— Allows the port to join a channel as a result of an LACP operation.
Default Configuration
The port is not assigned to any port-channel.
Console (config)# interface range port-channel 1-2
Console (config-if)#
5400_CLI.book Page 282 Wednesday, December 17, 2008 4:33 PM
To Next Page
Loading...
