EasyManua.ls Logo

Dell PowerConnect 5424 - Tunnel Source

Dell PowerConnect 5424
512 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Tunnel 435
User Guidelines
The
ipv6 tunnel routers-dns
command determines the string that the host uses for automatic tunnel
router lookup in IPv4 DNS procedure. By default, the string ‘ISATAP is used for the corresponding
automatic tunnel types.
Per tunnel only one string can represent the automatic tunnel router name. Using this command
overwrites the existing entry.
Example
The following example configures a global string "Dell_Tunnel_Router" to represent a specific automatic
tunnel router domain name..
tunnel source
The tunnel source Interface Tunnel Configuration
mode
command sets the local (source) tunnel
interface IPv4 address. Use the no form to delete the tunnel local address.
Syntax
tunnel source
{
auto
|
ip-address
ipv4-address
}
no tunnel source
auto
— The system minimum IPv4 address is used as the source address for packets sent on the
tunnel interface. If the IPv4 address is changed then the local address of the tunnel interface is
also changed.
ip4-address
— Pv4 address to use as the source address for packets sent on the tunnel interface.
The tunnel interface local address is not changed when the IPv4 address is moved to another
interface.
Default Configuration
No source address is defined.
Command Mode
Interface Tunnel Configuration mode.
User Guidelines
The configured source IPv4 address is used for forming the tunnel interface identifier. The interface
identifier is set to the 8 least significant bytes of the SIP field of the encapsulated IPv6 tunneled
packets.
Console (config)# interface tunnel 1
Console (config-tunnel)# tunnel isatap router Dell_Tunnel_Router
5400_CLI.book Page 435 Wednesday, December 17, 2008 4:33 PM

Table of Contents

Other manuals for Dell PowerConnect 5424

Related product manuals