172 Ethernet Configuration Commands
show ports jumbo-frame
The show ports jumbo-frame User EXEC mode command displays the jumbo frames configuration.
Syntax
show ports jumbo-frame
Default Configuration
This command has no default configuration.
Command Modes
User EXEC mode
User Guidelines
• There are no user guidelines for this command.
Example
The following example displays the jumbo frames configuration.
Symbol Errors For an interface operating at 100 Mb/s, the number of times there was an
invalid data symbol when a valid carrier was present.For an interface
operating in half-duplex mode at 1000 Mb/s, the number of times the
receiving media is non-idle (a carrier event) for a period of time equal to or
greater than slotTime, and during which there was at least one occurrence of
an event that causes the PHY to indicate 'Data reception error' or 'carrier
extend error' on the GMII.For an interface operating in full-duplex mode at
1000 Mb/s, the number of times the receiving media is non-idle (a carrier
event) for a period of time equal to or greater than minFrameSize, and during
which there was at least one occurrence of an event that causes the PHY to
indicate 'Data reception error' on the GMII.For an interface operating at 10
Gb/s, the number of times the receiving media is non-idle (a carrier event) for
a period of time equal to or greater than minFrameSize, and during which
there was at least one occurrence of an event that causes the PHY to indicate
'Receive Error' on the XGMII.
Received Pause Frames Counted MAC Control frames received with an opcode indicating the
PAUSE operation.
Transmitted Pause
Frames
Counted MAC Control frames transmitted on this interface with an opcode
indicating the PAUSE operation.
Console# show ports jumbo-frame
Jumbo frames are disabled
Jumbo frames will be enabled after reset
5400_CLI.book Page 172 Wednesday, December 17, 2008 4:33 PM
To Next Page
Loading...
Need help?
General
