Dell PowerConnect 5424 Command Line Interface Guide

LLDP Commands 265
show lldp neighbors
The show lldp neighbors Privileged EXEC mode command displays information about neighboring
devices discovered using Link Layer Discovery Protocol (LLDP).
Syntax
• show lldp neighbors [ ethernet interface ]
• interface — Ethernet interface
Command Modes
Privileged EXEC mode.
User Guidelines
There are no user guidelines for this command.
Example
The following example displays information about neighboring devices discovered using Link Layer
Discovery Protocol (LLDP).
Console# show lldp neighbors
Port Device ID Port ID System Name Capabilities
---- --------- ------- ----------- ------------
g1 0060.704C.73FE 1 ts-7800-2 B
g1 0060.704C.73FD 1 ts-7800-2 B
g2 0060.704C.73FC 9 ts-7900-1 B, R
g3 0060.704C.73FB 1 ts-7900-2 W
5400_CLI.book Page 265 Wednesday, December 17, 2008 4:33 PM

Dell PowerConnect 5424 Specifications

General

Ports	24 x 10/100/1000Base-T
Switching Capacity	48 Gbps
Forwarding Rate	35.7 Mpps
VLAN Support	Yes
Rack Mountable	Yes
Power Supply	Internal
MAC Address Table Size	8K entries
RAM	128 MB
Flash Memory	16 MB
Voltage Required	100-240V AC
Management	Web, CLI, SNMP
Operating Temperature	0°C to 45°C
Storage Temperature	-20°C to 70°C
Humidity	10% to 90% (non-condensing)
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab
Remote Management Protocol	SNMP, RMON, Telnet
Features	QoS, VLAN, Link Aggregation