Address Table Commands 95
Address Table Commands
bridge address
The bridge address VLAN Interface Configuration mode command adds a static MAC-layer station
source address to the bridge table. To delete the MAC address, use the no form of the bridge address
command (using the no form of the command without specifying a MAC address deletes all static
MAC addresses belonging to this VLAN).
Syntax
•
bridge address
mac-address
{
ethernet
interface | port-channel port-channel-number
} [
permanent
|
delete-on-reset
|
delete-on-timeout
|
secure
]
•
no bridge address
[
mac-address
]
•
mac-address
— A valid MAC address in the format of xx:xx:xx:xx:xx:xx.
•
interface —
A valid Ethernet port.
•
port-channel-number —
A valid port-channel number.
•
permanent —
The address can only be deleted by the
no bridge address
command.
•
delete-on-reset
— The address is deleted after reset.
•
delete-on-timeout —
The
address is deleted after "age out" time has expired.
•
secure
— The address is deleted after the port changes mode to unlock learning (
no port
security
command). This parameter is only available when the port is in learning locked
mode.
Default Configuration
No static addresses are defined. The default mode for an added address is
permanent
.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
• There are no user guidelines for this command.
5400_CLI.book Page 95 Wednesday, December 17, 2008 4:33 PM
To Next Page
Loading...
