Dell PowerConnect 5424 Command Line Interface Guide

Ethernet Configuration Commands 155
Default Configuration
The interface is set to full duplex.
Command Mode
Interface Configuration (Ethernet) mode.
User Guidelines
• Before attempting to force a particular duplex mode on the port operating at 10/100/1000 Mbps,
disable the auto-negotiation on that port.
• Half duplex mode can be set only for ports operating at 10 Mbps or 100 Mbps.
Example
The following example configures the duplex operation of Ethernet g5 to force full duplex operation.
negotiation
Use negotiation command to enable auto negotiation operation for the speed and duplex parameters of
a given interface. Use the no form of this command to disable it.
Syntax
• negotiation [ capability1 [capability2…capability5 ]]
• no negotiation
• capability — Specify the capabilities to advertise. Can be one or more of the following: 10h, 10f,
100h, 100f, 1000f. If unspecified defaults to list of all the capabilities of the port.
Default Configuration
Auto negotiation default is enabled.
Command Mode
Interface Configuration (Ethernet, Port-channel).
User Guidelines
• There are no user guidelines for this command.
Console(config)# interface ethernet g5
Console(config-if)# duplex full
5400_CLI.book Page 155 Wednesday, December 17, 2008 4:33 PM

Dell PowerConnect 5424 Specifications

General

Ports	24 x 10/100/1000Base-T
Switching Capacity	48 Gbps
Forwarding Rate	35.7 Mpps
VLAN Support	Yes
Rack Mountable	Yes
Power Supply	Internal
MAC Address Table Size	8K entries
RAM	128 MB
Flash Memory	16 MB
Voltage Required	100-240V AC
Management	Web, CLI, SNMP
Operating Temperature	0°C to 45°C
Storage Temperature	-20°C to 70°C
Humidity	10% to 90% (non-condensing)
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab
Remote Management Protocol	SNMP, RMON, Telnet
Features	QoS, VLAN, Link Aggregation