396 Syslog Commands
show logging file
The show logging file Privileged EXEC command displays the state of logging and the syslog messages
stored in the logging file.
Syntax
• show logging file
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode.
Buffer log:
11-Aug-2002 15:41:43: %LINK-3-UPDOWN: Interface FastEthernet0/0,
changed state to up
11-Aug-2002 15:41:43: %LINK-3-UPDOWN: Interface Ethernetg/0, changed
state to up
11-Aug-2002 15:41:43: %LINK-3-UPDOWN: Interface Ethernetg/1, changed
state to up
11-Aug-2002 15:41:43: %LINK-3-UPDOWN: Interface Ethernet1/2, changed
state to up
11-Aug-2002 15:41:43: %LINK-3-UPDOWN: Interface Ethernetg/3, changed
state to up
11-Aug-2002 15:41:43: %SYS-5-CONFIG_I: Configured from memory by console
11-Aug-2002 15:41:39: %LINEPROTO-5-UPDOWN: Line protocol on Interface
FastEthernet0/0, changed state to up
11-Aug-2002 15:41:39: %LINEPROTO-5-UPDOWN: Line protocol on Interface
Ethernet1/0, changed state to down
11-Aug-2002 15:41:39: %LINEPROTO-5-UPDOWN: Line protocol on Interface
Ethernet g/1, changed state to down
11-Aug-2002 15:41:39: %LINEPROTO-5-UPDOWN: Line protocol on Interface
Ethernet1/2, changed state to down
11-Aug-2002 15:41:39: %LINEPROTO-5-UPDOWN: Line protocol on Interface
Ethernet1/3, changed state to down
5400_CLI.book Page 396 Wednesday, December 17, 2008 4:33 PM
To Next Page
Loading...
