EasyManua.ls Logo

Dell PowerConnect 5424 - Back-Pressure

Dell PowerConnect 5424
512 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
158 Ethernet Configuration Commands
User Guidelines
Mdix Auto:
All possibilities to connect a PC with cross OR normal cables are supported and are
automatically detected.
Mdix ON
: It is possible to connect to a PC only with a normal cable and to connect to another switch
ONLY with a cross cable.
If MDIX is set to "no mdix", the device works opposite from the "MDIX On" behavior. With this
setting you can only use either an ethernet standard cross-over cable to connect to a PC, or an ethernet
standard cable to connect to another switch.
Example
In the following example, automatic crossover is enabled on g5.
back-pressure
The back-pressure Interface Configuration mode command enables Back Pressure on a given interface.
Use the no form of this command to disable Back Pressure.
Syntax
back-pressure
no back-pressure
Default Configuration
Back Pressure is disabled.
Command Mode
Interface Configuration (Ethernet, port-channel) mode.
User Guidelines
Back Pressure will operate only if duplex mode is set to half.
Example
In the following example Back Pressure is enabled on g5.
Console(config)# interface ethernet g5
Console(config-if)# mdix auto
Console(config)# interface ethernet g5
Console(config-if)# back-pressure
5400_CLI.book Page 158 Wednesday, December 17, 2008 4:33 PM

Table of Contents

Other manuals for Dell PowerConnect 5424

Related product manuals