EasyManua.ls Logo

Dell PowerConnect 5424 - Aggregating Ports

Dell PowerConnect 5424
512 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Spanning-Tree Commands 351
Command Modes
Global Configuration mode.
User Guidelines
The priority value must be a multiple of 4096.
The bridge with the lowest priority is elected to be the Root Bridge.
Example
The following example configures spanning-tree priority to 12288.
spanning-tree disable
The spanning-tree disable Interface Configuration mode command disables spanning-tree on a specific
port. To enable spanning-tree on a port use, the no form of this command.
Syntax
spanning-tree disable
no spanning-tree disable
Default Configuration
By default, all ports are enabled for spanning-tree.
Command Modes
Interface Configuration (Ethernet, port-channel) mode.
User Guidelines
When STP is disabled, the device will not forward STP BPDU's based on the Forward BPDU's setting.
Example
The following example disables spanning-tree on g5.
Console(config)# spanning-tree priority 12288
Console (config)# interface ethernet g5
Console (config-if)# spanning-tree disable
5400_CLI.book Page 351 Wednesday, December 17, 2008 4:33 PM

Table of Contents

Other manuals for Dell PowerConnect 5424

Related product manuals