Command Groups 45
LLDP Commands
exec-timeout Configures the interval that the system waits until
user input is detected.
Line Configuration
show line Displays line parameters. User EXEC
terminal history Enables the command history function for the current
terminal session.
User EXEC
terminal history size Cand history buffer size for the current terminal
session.
User EXEC
Command Group Description Access Mode
lldp enable (global) Enables Link Layer Discovery Protocol. Interface
Configuration
(Ethernet)
lldp enable (interface) Enables Link Layer Discovery Protocol (LLDP) on an
interface.
Interface
Configuration
(Ethernet)
lldp timer Specifies how often the software sends LLDP updates. Global
Configuration
lldp hold-multiplier Specifies the amount of time the receiving device should
hold a Link Layer Discovery Protocol packet before
discarding it.
Global
Configuration
lldp reinit-delay Specifies the minimum time an LLDP port will wait before
reinitializing LLDP transmission.
Global
Configuration
lldp tx-delay Specifies the delay between successive LLDP frame
transmissions initiated by value/status
changes in the LLDP local systems MIB.
Global
Configuration
lldp optional-tlv Specifies which optional TLVs from the basic set should be
transmitted.
Interface
Configuration
(Ethernet)
lldp management-
address
Specifies the management address to be advertised from an
interface.
Interface
Configuration
(Ethernet)
lldp med enable Enables LLDP Media Endpoint Discovery (MED) on an
interface.
Interface
Configuration
(Ethernet)
lldp med network-policy
(global)
Defines LLDP MED network policy. Global
Configuration
5400_CLI.book Page 45 Wednesday, December 17, 2008 4:33 PM
To Next Page
Loading...
Need help?
General
