Dell PowerConnect 5424 - Show Ports Storm-Control

Ethernet Configuration Commands 175
Example
The following example configures the maximum Broadcast rate 10 kilobytes per second.
show ports storm-control
The show ports storm-control Privileged EXEC mode command displays the storm control
configuration.
Syntax
show ports storm-control [ interface ]
• interface — A valid Ethernet port.
Default Configuration
This command has no default configuration.
Command Modes
Privileged EXEC mode
User Guidelines
• There are no user guidelines for this command.
Example
The following example displays the storm control configuration.
console(config)# interface ethernet g2
console(config-if)# port storm-control broadcast rate 10
Console# show ports storm-control
Port State Rate
[Kbits/Sec]
Included
----- ---------- ---------- ----------
g1 Disabled 3500 Broadcast
g2 Disabled 3500 Broadcast
g3 Disabled 3500 Broadcast
g4 Disabled 3500 Broadcast
g5 Disabled 3500 Broadcast
g6 Disabled 3500 Broadcast
g7 Disabled 3500 Broadcast
g8 Disabled 3500 Broadcast
5400_CLI.book Page 175 Wednesday, December 17, 2008 4:33 PM