162 Ethernet Configuration Commands
The displayed port configuration information includes the following:
•
Port
— The port number.
•
Port Type
— The port designated IEEE shorthand identifier. For example 1000Base-T refers to 1000
Mbps baseband signaling.
•
Duplex
— Displays the port Duplex status.
•
Speed
— Refers to the port speed.
•
Neg
— Describes the Auto-negotiation status.
•
Flow Control
— Displays the Flow Control status.
•
Back Pressure
— Displays the Back Pressure status.
•
MDIX Mode
— Displays the Auto-crossover status.
•
Admin State
— Displays whether the port is enabled or disabled.
show interfaces status
The show interfaces status User EXEC mode command displays the status for all configured interfaces.
Syntax
show interfaces status [ethernet interface
|
port-channel
port-channel-number
]
•
interface
— A valid Ethernet port.
•
port-channel-number —
A valid port-channel trunk index.
Default Configuration
This command has no default configuration.
Command Mode
Privilege EXEC mode
User Guidelines
• There are no user guidelines for this command.
Example
The following example displays the status for all configured interfaces.
5400_CLI.book Page 162 Wednesday, December 17, 2008 4:33 PM
To Next Page
Loading...
