Dell PowerConnect 5424 Command Line Interface Guide

Radius Commands 303
User Guidelines
• There are no user guidelines for this command.
Example
The following example sets the authentication and encryption key for all RADIUS communications
between the device and the RADIUS daemon to "dell-server".
radius-server retransmit
The radius-server retransmit Global Configuration mode command specifies the number of times the
software searches the list of RADIUS server hosts. Use the no form of this command to reset the default
configuration.
Syntax
• radius-server retransmit retries
• no radius-server retransmit
• retries — Specifies the retransmit value. (Range: 1 - 10)
Default Configuration
The default is 3 attempts.
Command Mode
Global Configuration mode.
User Guidelines
• There are no user guidelines for this command.
Example
The following example configures the number of times the software searches the list of RADIUS server
hosts to 5 attempts.
Console (config)# radius-server key dell-server
Console (config)# radius-server retransmit 5
5400_CLI.book Page 303 Wednesday, December 17, 2008 4:33 PM

Dell PowerConnect 5424 Specifications

General

Ports	24 x 10/100/1000Base-T
Switching Capacity	48 Gbps
Forwarding Rate	35.7 Mpps
VLAN Support	Yes
Rack Mountable	Yes
Power Supply	Internal
MAC Address Table Size	8K entries
RAM	128 MB
Flash Memory	16 MB
Voltage Required	100-240V AC
Management	Web, CLI, SNMP
Operating Temperature	0°C to 45°C
Storage Temperature	-20°C to 70°C
Humidity	10% to 90% (non-condensing)
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab
Remote Management Protocol	SNMP, RMON, Telnet
Features	QoS, VLAN, Link Aggregation