ACL Commands 83
User Guidelines
There are no user guidelines for this command.
Example
The following example binds (services) an ACL to VLAN 2.
show access-lists
The show access-lists Privileged EXEC mode command displays access control lists (ACLs) defined on
the device.
Syntax
•
show access-lists
[
name
]
•
name
— The name of the ACL.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode.
User Guidelines
There are no user guidelines for this command.
Example
The following example displays access lists defined on a device.
Console(config)# interface eth g1
Console(config-if)# service-acl input macl1
Console# show access-lists
IP access list ACL1
permit 234 172.30.40.1 0.0.0.0 any
permit 234 172.30.8.8 0.0.0.0 any
5400_CLI.book Page 83 Wednesday, December 17, 2008 4:33 PM
To Next Page
Loading...
