AAA Commands 89
ip http authentication
The ip http authentication Global Configuration mode command specifies authentication methods for
http. Use the no form of this command to return to the default.
Syntax
•
ip http authentication
method1
[
method2
...]
• no ip http authentication
•
method1
[
method2
...] — Specify at least one from the following table:
Default Configuration
The local user database is checked. This has the same effect as the command
ip http authentication
local
.
Command Mode
Global Configuration mode.
User Guidelines
• The additional methods of authentication are used only if the previous method returns an error, not if
it fails. To ensure that the authentication succeeds even if all methods return an error, specify
none
as
the final method in the command line.
Example
The following example configures the http authentication.
ip https authentication
The ip https authentication Global Configuration mode command specifies authentication methods for
https servers. Use the no form of this command to return to the default.
Keyword Source or destination
local Uses the local username database for authentication.
none Uses no authentication.
radius Uses the list of all RADIUS servers for authentication.
tacacs Uses the list of all TACACS servers for authentication.
Console (config)# ip http authentication radius local
Console (config)# ip http authentication tacacs local
5400_CLI.book Page 89 Wednesday, December 17, 2008 4:33 PM
To Next Page
Loading...
Need help?
General
