Dell PowerConnect 5424 Command Line Interface Guide

508 802.1x Commands
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
• Use the dot1x guest-vlan enable Interface Configuration command to enable unauthorized users on
an interface an access to the Guest VLAN. If the Guest VLAN is defined and enabled, the port
automatically joins the Guest VLAN when the port is unauthorized, and leaves the Guest VLAN when
the port becomes authorized. To get this functionality, the port should not be statically a member in
the Guest VLAN.
Examples
The following example
dot1x guest-vlan enable
The dot1x guest-vlan enable Interface Configuration mode command enables unauthorized users on the
interface access to the Guest VLAN. Use the no form of this command to disable the access.
Syntax
• dot1x guest-vlan enable
• no dot1x guest-vlan enable
Default Configuration
Disabled.
Command Mode
Interface Configuration (Ethernet) mode.
User Guidelines
• There is one global Guest VLAN in the switch, defined by the dot1x guest-vlan interface VLAN
configuration command.
Examples
The following example enables unauthorized users on the interface access to the Guest VLAN.
console config-if(Config-VLAN)#
console config-if(Config-VLAN)# dot1x guest-vlan enable
5400_CLI.book Page 508 Wednesday, December 17, 2008 4:33 PM

Dell PowerConnect 5424 Specifications

General

Ports	24 x 10/100/1000Base-T
Switching Capacity	48 Gbps
Forwarding Rate	35.7 Mpps
VLAN Support	Yes
Rack Mountable	Yes
Power Supply	Internal
MAC Address Table Size	8K entries
RAM	128 MB
Flash Memory	16 MB
Voltage Required	100-240V AC
Management	Web, CLI, SNMP
Operating Temperature	0°C to 45°C
Storage Temperature	-20°C to 70°C
Humidity	10% to 90% (non-condensing)
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab
Remote Management Protocol	SNMP, RMON, Telnet
Features	QoS, VLAN, Link Aggregation