Dell PowerConnect 5424 Command Line Interface Guide

System Management 413
Examples
The following table describes the significant fields shown in the display:
show system
The show system User EXEC mode command displays system information.
Syntax
• show system
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode.
User Guidelines
There are no user guidelines for this command.
Console> show sessions
Connecti
on
Host Address Port Byte
-------- -------------- -------- ----- ----
1 Remote device 172.16.1.1 23 89
2 172.16.1.2 172.16.1.2 23 8
Field Description
Connection Connection number
Host Remote host to which the device is connected through a Telnet session.
Address IP address of the remote host.
Port Telnet TCP port number
Byte Number of unread bytes for the user to see on the connection.
5400_CLI.book Page 413 Wednesday, December 17, 2008 4:33 PM

Dell PowerConnect 5424 Specifications

General

Ports	24 x 10/100/1000Base-T
Switching Capacity	48 Gbps
Forwarding Rate	35.7 Mpps
VLAN Support	Yes
Rack Mountable	Yes
Power Supply	Internal
MAC Address Table Size	8K entries
RAM	128 MB
Flash Memory	16 MB
Voltage Required	100-240V AC
Management	Web, CLI, SNMP
Operating Temperature	0°C to 45°C
Storage Temperature	-20°C to 70°C
Humidity	10% to 90% (non-condensing)
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab
Remote Management Protocol	SNMP, RMON, Telnet
Features	QoS, VLAN, Link Aggregation