Dell PowerConnect 5424 Command Line Interface Guide

TIC Commands 425
Default Configuration
Password aging is disabled.
Command Mode
Global Configuration mode.
User Guidelines
• The aging time is calculated from the day the password was defined, and not from the day the aging
was defined.
• After a password expires a user can login for another 3 times.
• 10 days before expiration a syslog message is generated.
Example
The following example configures configures 40 days as the aging time of global passwords.
passwords history
The passwords history Global Configuration mode command configures the number of password
changes that are required before a password in the local database can be reused. To remove the
requirement use the no form of this command.
Syntax
• passwords history number
• no passwords history
• number — The number of password changes before a password can be reused. (Range: 1-10).
Default Configuration
Passwords history is disabled.
Command Mode
Global Configuration mode.
User Guidelines
• The setting is relevant to local users passwords, line passwords and enable passwords.
• Password history is not checked during download of configuration.
• The history of passwords is kept even if the passwords history check is disabled.
• The history of passwords for a user is kept as long as the user is defined.
Console (config)# passwords aging username 40
5400_CLI.book Page 425 Wednesday, December 17, 2008 4:33 PM

Dell PowerConnect 5424 Specifications

General

Ports	24 x 10/100/1000Base-T
Switching Capacity	48 Gbps
Forwarding Rate	35.7 Mpps
VLAN Support	Yes
Rack Mountable	Yes
Power Supply	Internal
MAC Address Table Size	8K entries
RAM	128 MB
Flash Memory	16 MB
Voltage Required	100-240V AC
Management	Web, CLI, SNMP
Operating Temperature	0°C to 45°C
Storage Temperature	-20°C to 70°C
Humidity	10% to 90% (non-condensing)
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab
Remote Management Protocol	SNMP, RMON, Telnet
Features	QoS, VLAN, Link Aggregation