154 Ethernet Configuration Commands
speed
The speed Interface Configuration mode command configures the speed of a given Ethernet interface
when not using auto-negotiation. Use the no form of this command to restore the default.
Syntax
•
speed
{
10
|
100
|
1000
}.
• no speed
•
10
— Force 10 Mbps operation.
•
100
— Force 100 Mbps operation.
•
1000
— Force 1000 Mbps operation.
Default Configuration
Maximum port capability.
Command Mode
Interface Configuration (Ethernet, port-channel) mode.
User Guidelines
• The command ’
no speed
’ in port-channel context returns each port in the port-channel to its
maximum capability.
Example
The following example configures the speed operation of Ethernet g5 to force 100-Mbps operation.
duplex
The duplex Interface Configuration mode command configures the full/half duplex operation of a given
Ethernet interface when not using auto-negotiation. Use the no form of this command to restore the
default.
Syntax
•
duplex
{
half
|
full
}
• no duplex
•
half
— Force half-duplex operation
•
full
— Force full-duplex operation
Console(config)# interface ethernet g5
Console(config-if)# speed 100
5400_CLI.book Page 154 Wednesday, December 17, 2008 4:33 PM
To Next Page
Loading...
