Dell PowerConnect 5424 - Lldp Med Location

LLDP Commands 261
Command Mode
Interface Configuration (Ethernet) mode.
User Guidelines
There are no guidelines for this command.
lldp med location
The lldp med location Interface Configuration mode command configures location information for the
Link Layer Discovery Protocol (LLDP) Media Endpoint Discovery (MED) for an interface. Use the no
form of this command to delete location information for an interface.
Syntax
• lldp med location coordinate data
• no lldp med location coordinate
• lldp med location civic-address data
• no lldp med location civic-address
• lldp med location ecs-elin data
• no lldp med location ecs-elin
• coordinate — The location is specified as coordinates.
• civic-address — The location is specified as civic address.
• ecs-elin — The location is specified as ECS ELIN.
•data — The data format is as defined in ANSI/TIA 1057. Specifies the location as dotted
hexadecimal data: Each byte in hexadecimal character strings is two hexadecimal digits. Each byte
can be separated by a period or colon.
Default Configuration
The location is not configured.
Command Mode
Interface Configuration (Ethernet) mode.
User Guidelines
There are no guidelines for this command.
Example
The following example configures location information for the LLDP MED for an interface.
Console(config)#
lldp med location coordinate data
5400_CLI.book Page 261 Wednesday, December 17, 2008 4:33 PM