Ethernet Configuration Commands 159
port jumbo-frame
The port jumbo-frame Global Configuration mode command enables jumbo frames for the device. The
size of the port jumbo frame is 10K. Use the no form of this command to disable jumbo frames.
Syntax
• port jumbo-frame
• no port jumbo-frame
Default Configuration
Jumbo Frames are not enabled.
Command Mode
Global Configuration mode.
User Guidelines
• The command would be effective only after reset.
Example
In the following example, Jumbo Frames are enabled on the device.
clear counters
The clear counters User EXEC mode command clears statistics on an interface.
Syntax
•
clear counters
[
ethernet
interface
|
port-channel
port-channel-number
]
•
interface —
Valid Ethernet port.
•
port-channel-number —
Valid port-channel trunk index.
Default Configuration
This command has no default configuration.
Command Mode
User
EXEC mode.
User Guidelines
• There are no user guidelines for this command.
Console(config)# port jumbo-frame
5400_CLI.book Page 159 Wednesday, December 17, 2008 4:33 PM
To Next Page
Loading...
