Dell PowerConnect 5424 Command Line Interface Guide

Management ACL 273
management access-class
The management access-class Global Configuration mode command defines which management
Access-List is used. Use the no form of this command to disable restriction.
Syntax
• management access-class { console-only | name }
• no management access-class
• name — Name of the Access List. If unspecified, defaults to an empty Access-List. (Range: 1 - 32
characters)
• console-only — The device can be managed only from the console.
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode.
User Guidelines
• There are no user guidelines for this command.
Example
The following example configures an Access-List called ’mlist’ as the management Access-List.
show management access-list
The show management access-list Privileged EXEC mode command displays management access-lists.
Syntax
• show management access-list [ name ]
• name — Name of the Access List. If unspecified, defaults to an empty Access-List. (Range: 1 - 32
characters)
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode.
Console (config)# management access-class mlist
5400_CLI.book Page 273 Wednesday, December 17, 2008 4:33 PM

Dell PowerConnect 5424 Specifications

General

Ports	24 x 10/100/1000Base-T
Switching Capacity	48 Gbps
Forwarding Rate	35.7 Mpps
VLAN Support	Yes
Rack Mountable	Yes
Power Supply	Internal
MAC Address Table Size	8K entries
RAM	128 MB
Flash Memory	16 MB
Voltage Required	100-240V AC
Management	Web, CLI, SNMP
Operating Temperature	0°C to 45°C
Storage Temperature	-20°C to 70°C
Humidity	10% to 90% (non-condensing)
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab
Remote Management Protocol	SNMP, RMON, Telnet
Features	QoS, VLAN, Link Aggregation