EasyManua.ls Logo

Dell PowerConnect 5424 - Tunnel Isatap Query-Interval; Tunnel Isatap Solicitation-Interval

Dell PowerConnect 5424
512 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
436 Tunnel
Example
The following example sets the local (source) tunnel interface IPv4 address.
tunnel isatap query-interval
The tunnel isatap query-interval Global Configuration
mode
command configures the interval between
DNS Queries (before the IP address of the ISATAP router is known) for the automatic tunnel router
domain name. Use the no form of this command to return to default.
Syntax
tunnel isatap query-interval
seconds
no tunnel isatap query-interval
seconds
— Specify the number of seconds between DNS Queries. (Range: 1
0 – 3600)
Default Configuration
10 seconds.
Command Mode
Global Configuration mode.
User Guidelines
This command determines the interval of DNS queries before the IP address of the ISATAP router is
known. When the IP address is known the robustness level that is set by the
tunnel isatap robustness
global configuration command determines the refresh rate.
Example
The following example configures the interval between DNS Queries for the automatic tunnel router
domain to 60 seconds.
tunnel isatap solicitation-interval
The tunnel isatap solicitation-interval Global Configuration
mode
command configures the interval
between ISATAP router solicitations messages (when there is no active ISATAP router). Use the no form
of this command to return to default.
Console (config)# interface tunnel 1
Console (config-tunnel)# tunnel source auto
Console (config)# tunnel isatap query-interval 60
5400_CLI.book Page 436 Wednesday, December 17, 2008 4:33 PM

Table of Contents

Other manuals for Dell PowerConnect 5424

Related product manuals