EasyManua.ls Logo

Dell PowerConnect 5424 - Show Snmp Views

Dell PowerConnect 5424
512 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
342 SNMP Commands
User Guidelines
There are no user guidelines for this command.
Example
The following example displays the SNMP communications status.
.
show snmp views
The show snmp views Privileged EXEC mode command displays the configuration of views.
Syntax
show snmp views
[
viewname
]
viewname
The name of the view. Range: Up to 30 characters
Default Configuration
There is no default configuration for this command.
console# sh snmp
Traps are enabled.
Authentication trap is enabled.
Version 1,2 notifications
Target
Address
Type Community Version UDP Port Filter
name
TO sec Retries
Version 3 notifications
Target
Address
Type Username Security
Level
UDP Port Filter
name
TO sec Retries
System Contact:
System Location:
console#
5400_CLI.book Page 342 Wednesday, December 17, 2008 4:33 PM

Table of Contents

Other manuals for Dell PowerConnect 5424

Related product manuals