Dell PowerConnect 5424 Command Line Interface Guide

502 802.1x Commands
show dot1x users
The show dot1x users Privileged EXEC mode command displays 802.1X users for the switch.
Syntax
• show dot1x users [ username username ]
• username — Supplicant username . (Range: 1 - 160 characters)
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode.
User Guidelines
• There are no user guidelines for this command.
Example
The following example displays 802.1X users.
Login Time How long the user is logged in.
Last Authentication Time since last authentication.
Mac address The supplicant MAC address.
Authentication Method The authentication method used to establish the session.
Termination Cause The reason for the session termination.
console# show dot1x users
Username Session
Time
Last Auth Auth
Method
MAC Address Interface
-------- ----------- --------- -------- -------------- --------
Bob 1d3h 58m Remote 00:08:3b:79:87:8
7
g1
John 8h19m 2m None 00:08:3b:89:31:2
7
g2
5400_CLI.book Page 502 Wednesday, December 17, 2008 4:33 PM

Dell PowerConnect 5424 Specifications

General

Ports	24 x 10/100/1000Base-T
Switching Capacity	48 Gbps
Forwarding Rate	35.7 Mpps
VLAN Support	Yes
Rack Mountable	Yes
Power Supply	Internal
MAC Address Table Size	8K entries
RAM	128 MB
Flash Memory	16 MB
Voltage Required	100-240V AC
Management	Web, CLI, SNMP
Operating Temperature	0°C to 45°C
Storage Temperature	-20°C to 70°C
Humidity	10% to 90% (non-condensing)
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab
Remote Management Protocol	SNMP, RMON, Telnet
Features	QoS, VLAN, Link Aggregation