802.1x Commands 501
The following table describes the significant fields shown in the display:
Console# show dot1x ethernet g3
Interface Admin Mode Oper Mode Reauth
Control
Reauth Period Username
g3 Auto Unauthorized Ena 3600 Clark
State: held
Quiet period: 60
Tx period: 30
Max req: 2
Login Time: n/a
Last Authentication: n/a
MAC Address: 00:08:78:32:98:78
Authentication Method: Remote
Termination Cause: Supplicant logoff
Field Description
Interface The interface number.
Admin mode The admin mode of the port. Possible values are: Force-auth, Force-unauth, Auto
Oper mode The oper mode of the port. Possible values are: Authorized, Unauthorized.
Reauth Control Reauthentication control.
Reauth Period Reauthentication period.
Username The User-Name representing the identity of the Supplicant.
State The current value of the Authenticator PAE state machine.
Quiet period The number of seconds that the switch remains in the quiet state following a failed
authentication exchange (for example, the client provided an invalid password).
Tx period The number of seconds that the switch waits for a response to an Extensible
Authentication Protocol (EAP)-request/identity frame from the client before resending
the request.
Max req The maximum number of times that the switch sends an Extensible Authentication
Protocol (EAP)-request/identity frame (assuming that no response is received) to the
client before restarting the authentication process.
5400_CLI.book Page 501 Wednesday, December 17, 2008 4:33 PM
To Next Page
Loading...
Need help?
General
