Radius Commands 301
Radius Commands
radius-server host
The radius-server host Global Configuration mode command specifies a RADIUS server host.
Use the no form of this command to delete the specified RADIUS host.
Syntax
•
radius-server host
{
ip-address
|
hostname
} [
auth-port
auth-port-number
] [
timeout
timeout
]
[
retransmit
retransmit
] [
deadtime
deadtime
] [
key
key
] [
source
source
] [
priority
priority
] [
usage
type
]
no radius-server host
ip-address
•
ip-address
— IP address of the RADIUS server host.
•
hostname — Hostname of the RADIUS server host.
(Range: 1 - 158 characters)
•
auth-port-number
— Port number for authentication requests. The host is not used for
authentication if set to 0. If unspecified, the port number defaults to 1812. (Range: 0 - 65535)
•
timeout
— Specifies the timeout value in seconds. If no timeout value is specified, the global
value is used. (Range: 1 - 30)
•
retransmit
— Specifies the re-transmit value. If no re-transmit value is specified, the global
value is used. (Range: 1 - 10)
•
deadtime
— Length of time, in minutes, for which a RADIUS server is skipped over by
transaction requests. (Range: 0 - 2000)
•
key
— Specifies the authentication and encryption key for all RADIUS communications
between the device and the RADIUS server. This key must match the encryption used on the
RADIUS daemon. If no key value is specified, the global value is used. (Range: 1 - 128
characters)
•
source
— Specifies the source IP address to use for the communication. If no retransmit value
is specified, the global value is used. 0.0.0.0 is interpreted as request to use the IP address of
the outgoing IP interface.
•
priority
— Determines the order in which the servers are used, where 0 is the highest priority.
(Range: 0 - 65535)
•
type
— Specifies the usage type of the server. Can be one of the following values:
login
,
802.1x
or
all
. If unspecified, defaults to
all
.
5400_CLI.book Page 301 Wednesday, December 17, 2008 4:33 PM
To Next Page
Loading...
