EasyManua.ls Logo

Dell PowerConnect 5424 - Snmp-Server Trap Authentication; Snmp-Server Host

Dell PowerConnect 5424
512 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
332 SNMP Commands
Examples
The following example displays the command to enable SNMP traps.
snmp-server trap authentication
The snmp-server trap authentication Global Configuration mode command enables the switch to send
Simple Network Management Protocol traps when authentication fails. Use the no form of this
command to disable SNMP authentication failed traps.
Syntax
snmp-server trap authentication
no snmp-server trap authentication
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode.
User Guidelines
There are no user guidelines for this command.
Examples
The following example displays the command to enable authentication failed SNMP traps.
snmp-server host
The snmp-server host Global Configuration mode command specifies the recipient of Simple Network
Management Protocol notification operation. Use the no form of this command to remove the specified
host.
Console (config)# snmp-server enable traps
Console (config)# snmp-server trap authentication
5400_CLI.book Page 332 Wednesday, December 17, 2008 4:33 PM

Table of Contents

Other manuals for Dell PowerConnect 5424

Related product manuals