258 LLDP Commands
User Guidelines
There are no user guidelines for this command.
Example
The following example specifies which optional TLV (2)s from the basic set should be transmitted.
lldp management-address
The lldp management-address Interface Configuration mode command specifies the management
address that would be advertised from an interface. Use the no form of this command to stop advertising
management address information.
Syntax
•
lldp management-address
ip-address
• no management-address
•
ip-address
—
Specifies the management address to advertise.
Default Configuration
No IP address is advertised.
Command Modes
Interface Configuration (Ethernet) mode.
User Guidelines
• Each port can advertise one IP address.
• Only static IP addresses can be advertised.
Example
The following example specifies management address that would be advertised from an interface as
192.168.0.1.
Console(config)# interface ethernet g5
Console(config-if)# lldp optional-tlv sys-name
Console(config)# interface ethernet g5
Console(config-if)# lldp management-address 192.168.0.1
5400_CLI.book Page 258 Wednesday, December 17, 2008 4:33 PM
To Next Page
Loading...
