Dell PowerConnect 5424 Command Line Interface Guide

130 Clock
User Guidelines
• The sntp Broadcast client enable Interface Configuration mode command enables the device to
receive Broadcast transmissions globally and on ALL interfaces.
• Use the sntp client enable Interface Configuration mode command to enable the SNTP client on a
specific interface.
Examples
The following example enables the SNTP Broadcast clients.
sntp anycast client enable
The sntp anycast client enable Global Configuration mode command enables Anycast client. Use the no
form of this command to disable the polling for SNTP Broadcast client.
Syntax
• sntp anycast client enable
• no sntp anycast client enable
This command has no arguments or keywords.
Default Configuration
SNTP Anycast clients d isabled.
Command Mode
Global Configuration mode.
User Guidelines
• Polling time is determined by the sntp client poll timer Global Configuration mode command.
• Use the sntp client enable Interface Configuration mode command to enable the SNTP client on a
specific interface.
Examples
The following example enables Anycast clients.
Console (config)# sntp broadcast client enable
Console (config-if)# sntp anycast client enable
5400_CLI.book Page 130 Wednesday, December 17, 2008 4:33 PM

Dell PowerConnect 5424 Specifications

General

Ports	24 x 10/100/1000Base-T
Switching Capacity	48 Gbps
Forwarding Rate	35.7 Mpps
VLAN Support	Yes
Rack Mountable	Yes
Power Supply	Internal
MAC Address Table Size	8K entries
RAM	128 MB
Flash Memory	16 MB
Voltage Required	100-240V AC
Management	Web, CLI, SNMP
Operating Temperature	0°C to 45°C
Storage Temperature	-20°C to 70°C
Humidity	10% to 90% (non-condensing)
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab
Remote Management Protocol	SNMP, RMON, Telnet
Features	QoS, VLAN, Link Aggregation