Dell PowerConnect 5424 Command Line Interface Guide

360 Spanning-Tree Commands
User Guidelines
• There are no user guidelines for this command.
Example
The following example sets the configuration revision to 1.
show (mst)
The show MST Configuration mode command displays the current or pending MST region configuration.
Syntax
• show {current | pending}
• current — Indicates the current region configuration.
• pending — Indicates the pending region configuration.
Default Setting
This command has no default configuration.
Command Mode
MST Configuration mode.
User Guidelines
• The pending MST region configuration takes effect only after exiting the MST Configuration mode.
Example
The following example displays a pending MST region configuration.
Console(config) # spanning-tree mst configuration
Console(config-mst) # revision 1
Console(config-mst)# show pending
Pending MST configuration
Name:
Region1
Revision: 1
Instance Vlans Mapped State
-------- ------------ -------
0 1-9,21-4094 Enabled
1 10-20 Enabled
5400_CLI.book Page 360 Wednesday, December 17, 2008 4:33 PM

Dell PowerConnect 5424 Specifications

General

Ports	24 x 10/100/1000Base-T
Switching Capacity	48 Gbps
Forwarding Rate	35.7 Mpps
VLAN Support	Yes
Rack Mountable	Yes
Power Supply	Internal
MAC Address Table Size	8K entries
RAM	128 MB
Flash Memory	16 MB
Voltage Required	100-240V AC
Management	Web, CLI, SNMP
Operating Temperature	0°C to 45°C
Storage Temperature	-20°C to 70°C
Humidity	10% to 90% (non-condensing)
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab
Remote Management Protocol	SNMP, RMON, Telnet
Features	QoS, VLAN, Link Aggregation