Command Modes 67
IC (Interface Configuration) Mode
tacacs-server source-ip Specifies the source IP address that will be used for the communication
with TACACS servers.
tacacs-server timeout Sets the timeout value.
tacacs-server host Specifies a TACACS+ host.
tunnel isatap query-interval Configures the interval between DNS Queries (before the IP address of
the ISATAP router is known) for the automatic tunnel router domain
name.
tunnel isatap robustness Configures the number of DNS Query/Router Solicitation refresh
messages that the device sends.
tunnel isatap solicitation-
interval
Configures the interval between ISATAP router solicitations messages
(when there is no active ISATAP router).
username Establishes a username-based authentication system.
vlan database Enters the VLAN Database Configuration mode.
wrr-queue cos-map
Maps assigned CoS values to select one of the egress queues.
Command Description
back-pressure Enables Back Pressure on a given interface.
channel-group Associates a port with a Port-channel.
clear host dhcp Sets an IP address on the device.
description Adds a description to an interface.
dot1x auth-not-req Enables unauthorized users access to that VLAN
dot1x guest-vlan Defines a Guest VLAN.
dot1x guest-vlan enable Enables unauthorized users on the interface an access to the Guest VLAN.
dot1x mac-authentication Enables authentication based on the station’s MAC address.
dot1x radius-attributes vlan Enables user-based VLAN assignment.
dot1x traps mac-authentication
failure
Enables sending traps when a MAC address was failed in authentication of
the 802.1X MAC authentication access control.
dot1x max-req Sets the maximum number of times that the switch sends an EAP -
request/identity frame to the client, before restarting the authentication
process.
dot1x port-control Enables manual control of the authorization state of the port
dot1x re-authentication Enables periodic re-authentication of the client.
5400_CLI.book Page 67 Wednesday, December 17, 2008 4:33 PM
To Next Page
Loading...
