200 IGMP Snooping Commands
ip igmp snooping querier address
The ip igmp snooping querier address Interface Configuration mode command defines the source
IP address that the IGMP Snooping querier uses. Use the no form of this command to return to default.
Syntax
•
ip igmp snooping querier address
ip-address
• no ip igmp snooping querier address
•
ip-address —
Source IP address.
Default Configuration
If an IP address is configured for the VLAN, it is used as the source address of the IGMP snooping
querier.
Command Mode
Interface Configuration mode (VLAN).
User Guidelines
• If an IP address is not configured by this command, and no IP address is configured for the IGMP
querier VLAN interface, the qurier is disabled.
Example
The following example defines the source IP address to be used by the IGMP Snooping querier.
show ip igmp snooping mrouter
The show ip igmp snooping mrouter User EXEC mode command displays information on dynamically
learned Multicast router interfaces.
Syntax
•
show ip igmp snooping mrouter
[
interface
vlan-id
]
•
vlan_id —
VLAN ID value.
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode.
Console (config)#
ip igmp snooping querier address
ip-address
5400_CLI.book Page 200 Wednesday, December 17, 2008 4:33 PM
To Next Page
Loading...
