Dell PowerConnect 5424 Command Line Interface Guide

146 Configuration and Image
delete
The delete Privileged EXEC mode command deletes a file from a Flash memory device.
Syntax
• delete url
• url — The location URL or reserved keyword of the source file to be copied.
The following table shows keywords and URL prefixes:
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode.
User Guidelines
• Note that *.sys, *.prv, image-1 and image-2 files can't be deleted.
Examples
The following example deletes a file from Flash memory.
boot system
The boot system Privileged EXEC mode command specifies the system image that the device loads at
startup.
Syntax
• boot system { image-1 | image-2 }
• image-1 — Specifies image 1 as the system startup image.
• image-2 — Specifies image 2 as the system startup image.
Keyword Source or Destination
flash Source or destination URL for Flash memory. It's the default in case a URL is
specified without a prefix
startup-config Represents the startup configuration file.
Console# delete flash:test
Delete flash:test? [confirm]
5400_CLI.book Page 146 Wednesday, December 17, 2008 4:33 PM

Dell PowerConnect 5424 Specifications

General

Ports	24 x 10/100/1000Base-T
Switching Capacity	48 Gbps
Forwarding Rate	35.7 Mpps
VLAN Support	Yes
Rack Mountable	Yes
Power Supply	Internal
MAC Address Table Size	8K entries
RAM	128 MB
Flash Memory	16 MB
Voltage Required	100-240V AC
Management	Web, CLI, SNMP
Operating Temperature	0°C to 45°C
Storage Temperature	-20°C to 70°C
Humidity	10% to 90% (non-condensing)
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab
Remote Management Protocol	SNMP, RMON, Telnet
Features	QoS, VLAN, Link Aggregation