EasyManua.ls Logo

Dell PowerConnect 5424 - Ip Igmp Snooping Leave-Time-Out

Dell PowerConnect 5424
512 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
198 IGMP Snooping Commands
Default Configuration
The default value is 300 seconds.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
There are no user guidelines for this command.
Example
The following example configures the mrouter timeout to 200 seconds.
ip igmp snooping leave-time-out
The ip igmp snooping leave-time-out VLAN Interface Configuration mode command configures the
leave-time-out. If an IGMP report for a Multicast group is not received within the leave-time-out period
after an IGMP leave was received from a specific port, the current port is deleted from the member list of
that Multicast group. Use the no form of this command to configure the default leave-time-out.
Syntax
ip igmp snooping leave-time-out
{
time-out |
immediate-leave
}
no ip igmp snooping leave-time-out
time-out
— leave-time-out in seconds. (Range: 0 - 2147483647)
immediate-leave
— Specifies that the port should be immediately removed from the members list
after receiving IGMP Leave.
Default Configuration
The default leave-time-out configuration is 10 seconds.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
The leave timeout should be set greater than the maximum time that a host is allowed to respond to
an IGMP Query.
•Use
immediate leave
only where there is only one host connected to a port.
Console (config)# interface vlan 2
Console (config-if)# ip igmp snooping mrouter-time-out 200
5400_CLI.book Page 198 Wednesday, December 17, 2008 4:33 PM

Table of Contents

Other manuals for Dell PowerConnect 5424

Related product manuals