802.1x Commands 511
• After successful authentication the port remains member in the unauthenticated VLANs and in the
Guest VLAN. Other static VLAN configuration is not applied on the port.
• If the supplicant VLAN does not exist on the switch, the supplicant is rejected.
Examples
The following command enables user-based VLAN assignment.
show dot1x advanced
The show dot1x advanced Privileged EXEC mode command displays 802.1X advanced features for the
switch or for the specified interface.
Syntax
•
show dot1x advanced
[
ethernet
interface
]
•
interface —
Ethernet interface
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode.
User Guidelines
• There are no user guidelines for this command.
console config-if(Config)# dot1x radius-attributes vlan
5400_CLI.book Page 511 Wednesday, December 17, 2008 4:33 PM
To Next Page
Loading...
