244 LACP Commands
Default Configuration
The default port priority value is 1.
Command Mode
Interface Configuration (Ethernet) mode.
User Guidelines
• There are no user guidelines for this command.
Example
The following example configures the priority value for port g8 to 247.
lacp timeout
The lacp timeout Interface Configuration mode command assigns an administrative LACP timeout.
Use the no form of this command to reset the default administrative LACP timeout.
Syntax
•
lacp timeout
{
long | short
}
• no lacp timeout
•
long
— Specifies a long timeout value.
•
short
— Specifies a short timeout value.
Default Configuration
The default port timeout value is
long
.
Command Mode
Interface Configuration (Ethernet) mode.
User Guidelines
• There are no user guidelines for this command.
Example
The following example assigns an administrative LACP timeout for port g8 to a long timeout value.
Console (config)# interface ethernet g8
Console (config-if)# lacp port-priority 247
Console (config)# interface ethernet g8
Console (config-if)# lacp timeout long
5400_CLI.book Page 244 Wednesday, December 17, 2008 4:33 PM
To Next Page
Loading...
