Dell PowerConnect 5424 Command Line Interface Guide

IGMP Snooping Commands 195
IGMP Snooping Commands
ip igmp snooping (Global)
The ip igmp snooping Global Configuration mode command enables Internet Group Management
Protocol (IGMP) snooping. Use the no form of this command to disable IGMP snooping.
Syntax
• ip igmp snooping
• no ip igmp snooping
Default Configuration
IGMP snooping is disabled.
Command Mode
Global Configuration mode.
User Guidelines
• There are no user guidelines for this command.
Example
The following example enables IGMP snooping.
ip igmp snooping (Interface)
The ip igmp snooping Interface Configuration mode command enables Internet Group
Management Protocol (IGMP) snooping on a specific VLAN. Use the no form of this command to
disable IGMP snooping on a VLAN interface.
Syntax
• ip igmp snooping
• no ip igmp snooping
Console (config)# ip igmp snooping
5400_CLI.book Page 195 Wednesday, December 17, 2008 4:33 PM

Dell PowerConnect 5424 Specifications

General

Ports	24 x 10/100/1000Base-T
Switching Capacity	48 Gbps
Forwarding Rate	35.7 Mpps
VLAN Support	Yes
Rack Mountable	Yes
Power Supply	Internal
MAC Address Table Size	8K entries
RAM	128 MB
Flash Memory	16 MB
Voltage Required	100-240V AC
Management	Web, CLI, SNMP
Operating Temperature	0°C to 45°C
Storage Temperature	-20°C to 70°C
Humidity	10% to 90% (non-condensing)
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab
Remote Management Protocol	SNMP, RMON, Telnet
Features	QoS, VLAN, Link Aggregation