Dell PowerConnect 5424 Command Line Interface Guide

Line Commands 251
Command Mode
User EXEC mode.
User Guidelines
The command enables the command history for the current session. The default would be determined
by the history Line Configuration command.
Examples
The following example disables the command history function for the current terminal session.
terminal history size
The terminal history size EXEC mode command changes the command history buffer size for the
current terminal session. Use the no form of this command to reset the command history buffer size to
the default.
Syntax
• terminal history size number-of-commands
• no terminal history size
Default Configuration
The default is determined by the history size Line Configuration command.
Command Mode
User EXEC mode.
User Guidelines
• The maximum for the sum of all buffers is 256.
Examples
The following example configures the command history buffer size to 20 commands for the current
terminal session.
console# show line console
Interactive timeout: 10 minutes
History: 10
Console> terminal history size 20
5400_CLI.book Page 251 Wednesday, December 17, 2008 4:33 PM

Dell PowerConnect 5424 Specifications

General

Ports	24 x 10/100/1000Base-T
Switching Capacity	48 Gbps
Forwarding Rate	35.7 Mpps
VLAN Support	Yes
Rack Mountable	Yes
Power Supply	Internal
MAC Address Table Size	8K entries
RAM	128 MB
Flash Memory	16 MB
Voltage Required	100-240V AC
Management	Web, CLI, SNMP
Operating Temperature	0°C to 45°C
Storage Temperature	-20°C to 70°C
Humidity	10% to 90% (non-condensing)
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab
Remote Management Protocol	SNMP, RMON, Telnet
Features	QoS, VLAN, Link Aggregation