Dell PowerConnect 5424 Command Line Interface Guide

LLDP Commands 255
Default Configuration
Default — 30 seconds.
Command Modes
Global Configuration mode.
User Guidelines
There are no user guidelines for this command.
Examples
The following example specifies the system to send Link Layer Discovery Protocol (LLDP) updates every
50 seconds.
lldp hold-multiplier
The lldp hold-multiplier Global Configuration mode command specifies the amount of time the
receiving device should hold a Link Layer Discovery Protocol (LLDP) packet before discarding it. Use the
no form of this command to revert to the default setting.
Syntax
• lldp hold-multiplier number
• no lldp hold-multiplier
• number — Specifies the hold time to be sent in the LLDP update packets as a multiple of the
timer value. (Range: 2 - 10)
Default Configuraiton
The default configuration is 4.
Command Modes
Global ConfigurationConfiguration mode.
User Guidelines
• The actual time-to-live value used in LLDP frames can be expressed by the following formula: TTL =
min(65535, LLDP-Timer * LLDP-HoldMultiplier). For example, if the value of LLDP timer is '30', and
the value of the LLDP hold multiplier is '4', then the value '120' is encoded in the TTL field in the
LLDP header.
Console (config) # lldp timer 50
5400_CLI.book Page 255 Wednesday, December 17, 2008 4:33 PM

Dell PowerConnect 5424 Specifications

General

Ports	24 x 10/100/1000Base-T
Switching Capacity	48 Gbps
Forwarding Rate	35.7 Mpps
VLAN Support	Yes
Rack Mountable	Yes
Power Supply	Internal
MAC Address Table Size	8K entries
RAM	128 MB
Flash Memory	16 MB
Voltage Required	100-240V AC
Management	Web, CLI, SNMP
Operating Temperature	0°C to 45°C
Storage Temperature	-20°C to 70°C
Humidity	10% to 90% (non-condensing)
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab
Remote Management Protocol	SNMP, RMON, Telnet
Features	QoS, VLAN, Link Aggregation