Address Table Commands 113
show ports security addresses
The show ports security addresses Privileged EXEC mode command displays the current dynamic
addresses in locked ports.
Syntax
•
show ports security addresses
[
ethernet
interface
|
port-channel
port-channel-number
]
•
interface
— A valid Ethernet port
.
•
port-channel-number —
A valid port-channel number
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode.
User Guidelines
There are no user guidelines for this command.
Example
This example displays dynamic addresses in all currently locked ports.
Frequency: Minimum time in seconds between consecutive traps
Counter: Number of actions since last trap
Console# show ports security addresses
Port Status Learning Current Maximum
---- -------- -------- ------- -------
g1 Enabled Max-addresses 2 3
g2 Disabled Max-addresses - 128
g3 Enabled Lock NA NA
5400_CLI.book Page 113 Wednesday, December 17, 2008 4:33 PM
To Next Page
Loading...
