208 IP Addressing Commands
Command Mode
Global Configuration mode.
User Guidelines
• There are no User Guidelines for this command.
Example
The following example defines an ip default gateway.
show ip interface
The show ip interface User EXEC mode command displays the usability status of interfaces configured
for IP.
Syntax
•
show ip interface
[
ethernet
interface-number
|
vlan
vlan-id |
port-channel
number
]
•
ethernet
interface-number
— Valid port number.
•
vlan
vlan-id
—VLAN number.
•
port-channel
number
— Port-channel number.
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode.
User Guidelines
• There are no user guidelines for this command.
Example
The following example the displays the usability status of interfaces configured for IP.
Console(config)# ip default-gateway 192.168.1.1
5400_CLI.book Page 208 Wednesday, December 17, 2008 4:33 PM