256 LLDP Commands
Examples
The following example specifies the amount of time the receiving device should hold a Link Layer
Discovery Protocol (LLDP) packet to 10 before discarding it.
lldp reinit-delay
The lldp reinit-delay Global Configuration mode command specifies the minimum time an LLDP port
waits before reinitializing LLDP transmissions. Use the no form of this command to revert to the
default setting.
Syntax
•
lldp reinit-delay
seconds
• no lldp reinit-delay
•
seconds
—
Specifies the minimum time in seconds an LLDP port will wait before reinitializing
LLDP transmissions. (Range 1 - 10 seconds)
Default Configuraiton
2 seconds.
Command Modes
Global Configuration mode.
User Guidelines
There are no user guidelines for this command.
Examples
The following example pecifies the minimum time an LLDP port will wait before reinitializing LLDP
transmissions to 5 seconds.
lldp tx-delay
The lldp tx-delay Global Configuration mode command specifies the delay between successive LLDP
frame transmissions initiated by value/status changes in the LLDP local systems MIB. Use the no form of
this command to revert to the default setting.
Console (config) # lldp hold-multiplier 10
Console (config) # lldp reinit-delay 5
5400_CLI.book Page 256 Wednesday, December 17, 2008 4:33 PM
To Next Page
Loading...
