100 Address Table Commands
bridge multicast forward-all
The bridge multicast forward-all Interface Configuration mode command enables forwarding of all
Multicast packets on a port. To restore the default, use the no form of the bridge multicast forward-all
command.
Syntax
•
bridge multicast forward-all
{
add
|
remove
}
{
ethernet
interface-list | port-channel port-channel-
number-list
}
• no bridge multicast forward-all
•
add
— Adds ports to the group.
•
remove
— Removes ports from the group.
•
interface-list
— Separate non consecutive valid Ethernet ports with a comma and no spaces; a
hyphen is used to designate a range of ports.
•
port-channel-number-list
— Separate non consecutive valid port-channels with a comma and no
spaces; a hyphen is used to designate a range of port-channels.
Default Configuration
Disable forward-all on the specified interface.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
There are no user guidelines for this command.
Example
In this example all Multicast packets on port g8 are forwarded.
bridge multicast forbidden forward-all
The bridge multicast forbidden forward-all Interface Configuration mode command forbids a port to be
a forward-all-Multicast port. To restore the default, use the no form of the bridge multicast forward-all
command.
Console (config)# interface vlan 2
Console (config-if)# bridge multicast forward-all add ethernet
g8
5400_CLI.book Page 100 Wednesday, December 17, 2008 4:33 PM
To Next Page
Loading...
Need help?
General
