Dell PowerConnect 5424 Command Line Interface Guide

Line Commands 247
Line Commands
line
The line Global Configuration mode command identifies a specific line for configuration and enters
the Line
Syntax
• line {console | telnet | ssh}
• console — Console terminal line.
• telnet — Virtual terminal for remote console access (Telnet).
• ssh — Virtual terminal for secured remote console access (SSH).
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode.
User Guidelines
• There are no user guidelines for this command.
Examples
The following example configures the device as a virtual terminal for remote console access.
speed
The speed Line Configuration mode command sets the line baud rate.
Console(config)# line telnet
Console(config-line)#
5400_CLI.book Page 247 Wednesday, December 17, 2008 4:33 PM

Dell PowerConnect 5424 Specifications

General

Ports	24 x 10/100/1000Base-T
Switching Capacity	48 Gbps
Forwarding Rate	35.7 Mpps
VLAN Support	Yes
Rack Mountable	Yes
Power Supply	Internal
MAC Address Table Size	8K entries
RAM	128 MB
Flash Memory	16 MB
Voltage Required	100-240V AC
Management	Web, CLI, SNMP
Operating Temperature	0°C to 45°C
Storage Temperature	-20°C to 70°C
Humidity	10% to 90% (non-condensing)
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab
Remote Management Protocol	SNMP, RMON, Telnet
Features	QoS, VLAN, Link Aggregation