Dell PowerConnect 5424 Command Line Interface Guide

User Interface 443
configure
The configure Privileged EXEC mode command enters the Global Configuration mode.
Syntax
• configure
This command has no keywords or arguments.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode.
User Guidelines
• There are no user guidelines for this command.
Example
In the following example, because no keyword is entered, a prompt is displayed. After the keyword is
selected, a message confirming the command entry method is displayed.
exit(configuration)
The exit command exits any configuration mode to the next highest mode in the CLI mode hierarchy.
Syntax
•exit
Default Configuration
This command has no default configuration.
Command Mode
All command modes.
User Guidelines
• There are no user guidelines for this command.
Console# configure
Console (config)#
5400_CLI.book Page 443 Wednesday, December 17, 2008 4:33 PM

Dell PowerConnect 5424 Specifications

General

Ports	24 x 10/100/1000Base-T
Switching Capacity	48 Gbps
Forwarding Rate	35.7 Mpps
VLAN Support	Yes
Rack Mountable	Yes
Power Supply	Internal
MAC Address Table Size	8K entries
RAM	128 MB
Flash Memory	16 MB
Voltage Required	100-240V AC
Management	Web, CLI, SNMP
Operating Temperature	0°C to 45°C
Storage Temperature	-20°C to 70°C
Humidity	10% to 90% (non-condensing)
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab
Remote Management Protocol	SNMP, RMON, Telnet
Features	QoS, VLAN, Link Aggregation