48 Command Groups
Port Monitor Commands
QoS Commands
Command Group Description Access Mode
port monitor Starts a port monitoring session. Interface
Configuration
show ports monitor Displays the port monitoring status. User EXEC
Command Group Description Access Mode
qos Enables quality of service (QoS) on the device
and enters QoS basic or advance mode.
Global Configuration
show qos Displays the QoS status. User EXEC
wrr-queue cos-map
Maps assigned CoS values to select one of
the egress queues.
Global Configuration
wrr-queue bandwidth Assigns Weighted Round Robin (WRR)
weights to egress queues.
Interface Configuration
priority-queue out num-of-
queues
Enables the egress queues to be expedite
queues
.
Global Configuration
traffic-shape Sets the shaper on an egress port. Interface Configuration
rate-limit (Ethernet) Limits the rate of the incoming traffic. Interface Configuration
(Ethernet, Port-Channel)
show qos interface Displays interface QoS data. User EXEC
qos map dscp-queue Modifies the DSCP to CoS map. Global Configuration
qos trust (Global) Configures the system to basic mode and the
"trust" state.
Global Configuration
qos trust (Interface)
Enables each port trust state
Interface Configuration
qos cos Configures the default port CoS value. Interface Configuration
show qos map Displays all the maps for QoS. User EXEC
5400_CLI.book Page 48 Wednesday, December 17, 2008 4:33 PM
To Next Page
Loading...
